Contents x
    Blitz Power Onboarding Guide
    • 05 Mar 2024
    • 1 Minute to read
    • Contributors
    • Dark
      Light
    • PDF
    Contents

    Blitz Power Onboarding Guide

    • Updated on 05 Mar 2024
    • 1 Minute to read
    • Contributors
    • Dark
      Light
    • PDF
    Article summary

    This guide describes how to onboard Blitz chargers with Tap.

    Onboarding in this context means getting the charger communicating with Tap. If you are looking for a complete guide for setting up an account and configuring your locations, see our Quick Start Guide.

    To connect a Blitz Power charger, you will need to be physically located at the charger with a laptop. You can either connect to the charger using a USB-C cable, or connect the laptop to the internet on the same LAN network as the charger.

    1. Connect the charger to your laptop with a USB-C cable. If the charger is connected to the internet via LAN, you can alternatively just connect the laptop to the same LAN network.
    2. Open a web browser on a laptop. Enter the URL: http://ev3000.local:3000
    3. Login using the following credentials:

    Username: operator
    Password: blitzoperator91500591

    1. Select Quick Setup.
    2. Navigate to Network. The next step depends on whether you are using a wired (LAN) internet connection, or a Tap SIM card.
      blitzpower setup1.png

    Wired/LAN Internet Connection

    1. Select "DHCP". This will automatically fill in IP Address and Subnet Mask.
    2. Your Gateway is the IP, but with the numbers behind the last period replaced with a 1. For example: if your IP is 192.123.4.56, then your Gateway is 192.123.4.1

    Tap SIM Card

    1. Enter the following details:

    SIM Pin: - leave blank -
    APN: Tapelectric

    1. Save the new fields.

    1. Navigate to Charge Points.

    2. Select "Configure All".

    3. Set Release Charging Mode to OCPP.

    4. Set OCPP Provider to Tap Electric.

    5. Copy the Charge Point Serial No., you will need to paste this into Tap.

    6. Click Save.
      blitzpower setup2.png

    7. Open the Tap app. Navigate to Locations > connect new charger
      locationsHome1.png

    8. Select Blitz Power.

    9. Select Enter Charger ID.

    10. After a minute the charger should appear in the list and you can proceed with onboarding.
      chargerOnboard.png

    What's Next